CNC Machinist - 2nd Shift

Cannonball Recruiting LLC

York, PA, USA

Published: 6/14/2022

Manufacturing

Full Time

CNC Machinist

Pay: $30-37/hr.

Shift: 3pm to 1am (Mon-Thu)

Description:

The CNC Machinist will set-up and operate CNC Mills & Lathes to fabricate metallic and non-metallic parts.

Requirements:

Setup, and operate various CNC equipment with minimal supervision.
Must have Proficient Knowledge of a variety of controls (Mazak, Fanuc, etc) with the ability to perform manual CNC program edits as required to complete job work scope.
Read and interpret customer drawings with an understanding of Geometric Dimensioning and Tolerances per ANSI Y-14.5.
Inspect work produced (1st piece and in-process inspection) using precision measuring equipment including: micrometers, bore gauges, dial calipers, or other measuring instruments to verify conformance to specifications. Maintain tolerances as close as 0.002” over 55” diameter.
Where required, document inspection results on supplied IDS Sheets and/or Inspection Prints.
Keep equipment (machine, gauging, tooling, etc) clean and well maintained and maintain a clean and orderly work area.
Follow preventative maintenance procedures on equipment as prescribed by supervisor and report operating difficulties of equipment.
Document daily activities to assure performance in accordance with job standards.

Job Duties:

Setup and operate CNC Mills/Lathes – Utilize knowledge of working properties and machining processes for a wide variety of materials such as stainless steel, Monel, Hastalloy, other nickel alloys, cast iron, carbon steel, bronze, aluminum, plastics, etc.
Manufacture components within the allotted time estimates provided on job travelers.
Ensure customer satisfaction with products and service.
Make process recommendations for improved efficiency and works with the CNC Programmer to optimize processes, programs and cutting tools.

Additional Qualifications:

The following skills and qualifications are a plus but are not required for this position:

Benefits: